[CRTech] Christian Radio Tech [MSG 84288]
[Thread Prev] [-- Thread Index --] [Thread Next] [Date Prev] [-- Date Index --] [Date Next]
Heliax cable bend?
To: "CRTech" <crtech@crtech.org>
Subject: Heliax cable bend?
From: "Bill Hurne" <billhurne@pilgrimradio.com>
Date: Thu, 15 Nov 2018 11:11:24 -0800
Content-language: en-us
Thread-index: AdR9FuQr/yBOy+ElSYqLHkzHi9UCJA==

Re-working RF plumbing at an installation, want to straighten a 90 degree bend near end of in 3 inch 50 ohm corrugated Heliax.    I think it is HJ8-50B, but not sure.  Existing Cable bend has about a 20 inch radius, recommended radius is no less than 30 inches.   It is working fine with the 20 inch radius and is pressurized.

 

Would I be safe to straighten the bend?   Would straightening cause damage requiring cutting off the bend and adding cable?   Of course work needs to be done while off air, just want to know how long we will be off, etc.

 

Bill Hurne
Chief Engineer
Pilgrim Radio

 

P: 775-883-5647  Ext 18


6363 U.S. Hwy. 50 East
Carson City, NV  89701

 

www.pilgrimradio.com

 

cid:f_jmhtzcok1

 

 

Follow-Ups: Re: Heliax cable bend?
(Rick Jesse <javajava56@gmail.com>, 18 Nov 2018 13:49:34 -0000)
Re: Heliax cable bend?
(Kevin Kidd <kkbroadcastengineering@gmail.com>, 18 Nov 2018 22:35:24 -0000)
Prev by date: Re: RDS Encoder?
(Dave Land, 15 Nov 2018 18:09:49 -0000)
Next by date: RE: RDS Encoder?
(Ben Barber, 15 Nov 2018 20:21:42 -0000)
Prev by thread: RE: RE: RDS Encoder?
(Bill Hurne, 16 Nov 2018 02:22:21 -0000)
Next by thread: Re: Heliax cable bend?
(Rick Jesse, 18 Nov 2018 13:49:34 -0000)
CRTech.org