Not particularly familiar with that.
I know there are normalize settings in NexGen. Perhaps that may help?
But again, it’s been a long time since we needed to mess with any settings. Not familiar with where they might be.
Not feeling well, but still plugging on as we’re in the midst of Sharathon prep here.
Hope it works out.
You might check with RCS/NexGen’s helps on-line or their tech forums. Tech support is usually very responsive.
From: Jim Sanders [mailto:JSanders@AmbassadorAdvertising.com]
Sent: Tuesday, September 25, 2018 3:10 PM
Subject: [CRTech] NexGen Record Capture
We’re working with a station which uses NexGen to record capture one of our programs off the AMR-100.
However, one of several files consistently sounds over-modulated. We know the files are all the same level as we have fetched the file(s) off their receiver and they’re all at our standard -6dBFS.
My question is this . . . do you know if NexGen allows you to set gain boost or trim based on each record capture event? This seems the only logical explanation for the problem. If we’re right and you’re familiar with the software, could you point us to where the setting lives?
Or, is there something we’re missing??