[CRTech] Christian Radio Tech [MSG 83743]
[Thread Prev] [-- Thread Index --] [Thread Next] [Date Prev] [-- Date Index --] [Date Next]
To: CRTech <crtech@crtech.org>, "mbohnett43@bevcomm.ne" <mbohnett43@bevcomm.ne>
Subject: Phunny
From: John Broomall <johnbroomall@yahoo.com>
Date: Mon, 10 Sep 2018 21:40:44 +0000 (UTC)
Content-length: 6406
Dkim-signature: v=1; a=rsa-sha256; c=relaxed/relaxed; d=yahoo.com; s=s2048; t=1536615647; bh=ihgs2wyh+VQUOtz0G0y32Sy6yBJah2945sy5GY12enA=; h=Date:From:Reply-To:To:In-Reply-To:References:Subject:From:Subject; b=XQ/qMBI1cgYtFdtnzg71h9Y6EAtBIrHMovXkC88PMoioGfh5Q3gGQIF2Qa4wxrtz6qFSyb4EUjBLTRflO6d7vfc9tR5vNzd8k07q4grt52jCgoo+IcGSqgUnKBCjAgoMZPqS4pRIMRyJpdiaVXTMbHlSy9ApNj/ReBrro6bvG1CHaVl0ky6YIg9UwSIvx4Ek1CPiwcWLwRcmSrYDWX5+P8MwaHuD98LaEohPWrEo+fUssSrVyKNJpCR8dWfnXiHBAuX0AIlufGHi7R/WBn2FHHn0m8SX1CEfxg/uKUs813grV/AsgBUaR77czcQAJ4MWzoxGigM1nyU+lfuBj2oQ3w==
In-reply-to: <830893665.249995.1536607774559.JavaMail.zimbra@bevcomm.net>
References: <830893665.249995.1536607774559.JavaMail.zimbra@bevcomm.net>
Reply-to: John Broomall <johnbroomall@yahoo.com>
An American Tower site with steal struts!

John O. Broomall, Sr.
WPCG/Grace Radio 102.9
Christian Community Broadcasters
284 Louie Lane, Canton GA 30115
(770) 720-1037

On Monday, September 10, 2018, 3:30:04 PM EDT, Mark Carol Bohnett <mbohnett43@bevcomm.net> wrote:

Dear Sirs

We have a Full Power site in Minnesota that is fed primarily with a IP based signal.  The emergency back up has been an off-air broadcast receiver but the antenna is only 15ft off the ground, directly in behind a large self supporting tower (lots of grounded steel).  Depending on the day, the signal is fair but never clean.  In fact I have to point my antenna between the steal struts to get any signal. 

If I move the antenna and pole to the other side of the tower, the signal and sound quality is perfect.  The problem is the site is owned by American Tower who charges you for the very air you breath while on site!  We are attempting not to add more monthly costs to a moderately supported signal; therefore, we are searching for an alternative.

I was commissioned to use a "car radio" for a test (and to my surprise) and the audio quality was actually better that the professional receiver. 

Now I have to build a site with a car radio and interface it into the broadcast world.  I have used in the past the Bogen impedance matching transformers.  The spec is 10K input to 600 balanced out.  The speaker output of the radio is 8 ohmn therefore, I am looking for a 8 ohmn to 600 ohmn transformer.  I found the "Classic 119DA" transformer but they are pretty pricey.  Has anyone found (in this same or like situation) some "miracle" cure for matching a car radio into a line level device (preferably without a amplifier in between)?

If not, I'll probably go with the Bogens and hope for the best, but I wanted to see if any one had found a better alternative before I build the site.

Any thoughts would be appreciated.

E. Mark (MN)
References: Radio for Radio
(Mark Carol Bohnett <mbohnett43@bevcomm.net>, 10 Sep 2018 19:29:59 -0000)
Prev by date: Re: Radio for Radio
(Jim Turvaville, 10 Sep 2018 20:06:17 -0000)
Next by date: Email service?
(Dave Land, 11 Sep 2018 13:42:12 -0000)
Prev by thread: Re: Radio for Radio
(vern@wa0rcr.com vern@wa0rcr.com, 15 Sep 2018 02:53:16 -0000)
Next by thread: RE: Radio for Radio
(Mike Price, 11 Sep 2018 15:14:56 -0000)