[CRTech] Christian Radio Tech [MSG 82254]
[Thread Prev] [-- Thread Index --] [Thread Next] [Date Prev] [-- Date Index --] [Date Next]
Re: AMR-100 signal change
To: CRTech <crtech@crtech.org>
Subject: Re: AMR-100 signal change
From: Willie Barnett <wbradiolists@gmail.com>
Date: Mon, 26 Feb 2018 12:28:48 -0500
Dkim-signature: v=1; a=rsa-sha256; c=relaxed/relaxed; d=gmail.com; s=20161025; h=mime-version:in-reply-to:references:from:date:message-id:subject:to; bh=5cdy0OhKpF3kqmdcHNY6paTuvbHhMEucuWis+Fuer7c=; b=T8hKYc79YuSFXvFYkeBIMkR8eRkoYYIMDkxVXTKXSZa9hAs73IYVkoEAXkAU9yGr+E e4bNGaCYSRwYMFo1Z9bEtEhm7bzLWnM62Tvm4ClVD09o+M7xtVn8pkNmoJmzVVAJAeTH NXPp9d3wpLd/kv44caJpPLTXO0IM3BUamYZuypfWLdo7taWf5eKNEY0W3Pyt+lusEYmG FL50aYGlhB/Ri/G3XQ9nMhQq1WMXwppl9QIBtFfVev9m2PcjTGF4UwNMjQTOB+CKKsxD kUKVYy5AY9/kwae0/VMwNn7H93kHsOr/iQkvtxtnsAVKSTswAndxz/qXKv8ogX1BUwRb F4aA==
In-reply-to: <BE1C234ADBB46945862CECBEFC6E7C5B0106B42523@AAA-EXCH2010.AmbassadorAdvertising.local>
References: <CAOkhgWqkQUtFPOeL=upJsyMGdRe6ptYaN7-aCc9APg7L7OZTqQ@mail.gmail.com> <1960344191.5747647.1519664904429@mail.yahoo.com> <BE1C234ADBB46945862CECBEFC6E7C5B0106B42523@AAA-EXCH2010.AmbassadorAdvertising.local>
This happened well before that will happen. (About 9:45AM Eastern)

Swapped cables made no difference. All other receivers still show normal EbNo values.

It is an older receiver, which MIGHT have a "weaker" front end... so if a "neighboring" satellite signal changed, it MIGHT be just enough to affect THAT receiver's signal, while not affecting the others.

Willie...


On Mon, Feb 26, 2018 at 12:22 PM, Jim Sanders <JSanders@ambassadoradvertising.com> wrote:
We are on the cusp of sun transit outage.

From: JIm Turvaville [jimturbo61@yahoo.com]
Sent: Monday, February 26, 2018 9:08 AM
To: CRTech
Subject: Re: [CRTech] AMR-100 signal change

Not an AMBOS user, but typically when this happens on the receivers it more often indicates an aging LNB or moisture in a coax connection between you and the dish.  

Since you're also using a splitter of some kind to feed that signal to more than 1 receiver, it could be a culprit, or the source powering the LNB may be losing the ability to provide sufficient current needed.  

All of which would come to mind before a failing receiver, IME. 
 
Jim "Turbo" Turvaville 
SBE Certified Radio Engineer 
Turbo Technical Services 
 PH: 719-459-1859 



From: Willie Barnett <wbradiolists@gmail.com>
To: CRTech <crtech@crtech.org>
Sent: Monday, February 26, 2018 10:45 AM
Subject: [CRTech] AMR-100 signal change

Just wondering if anyone else has noticed a drop in signal from your AMBOS receiver(s)? One of them here has dropped by about 1.5 dB to the mid 7's, the other is still the same as always. (Low 9's)

I swapped input connections. No changes to either unit.

The one with the lower EbNo reported a loss of signal earlier, and it's logs appear to have been reset at about that same time. Remote units, and our backup, all show steady signal and about 1/8 the BER of the unit that "glitched".

I hope it's not indicating a receiver failure! Backups of parameters have been made... just in case.

Willie...




References: AMR-100 signal change
(Willie Barnett <wbradiolists@gmail.com>, 26 Feb 2018 16:45:41 -0000)
Re: AMR-100 signal change
(JIm Turvaville <jimturbo61@yahoo.com>, 26 Feb 2018 17:08:47 -0000)
RE: AMR-100 signal change
(Jim Sanders <JSanders@AmbassadorAdvertising.com>, 26 Feb 2018 17:22:36 -0000)
Prev by date: RE: AMR-100 signal change
(Jim Sanders, 26 Feb 2018 17:22:36 -0000)
Next by date: FW: SES-2 Sun outages
(Jim Sanders, 26 Feb 2018 17:35:22 -0000)
Prev by thread: RE: AMR-100 signal change
(Jim Sanders, 26 Feb 2018 17:22:36 -0000)
Next by thread: Re: AMR-100 signal change
(Schmitke, Gregory I, 26 Feb 2018 17:09:53 -0000)
CRTech.org