Everyone, many thanks. I have the manual without the schematic also. I should have indicated that.
I was looking for the schematic because the front end is over loading from 1460 kHz across the street and the station I need to monitor is 24 miles away on 960 kHz. I was able to figure something out without the schematic today. I made an adjustable attenuator with F connectors. I put it between the receiver and the antenna and turned it down until the interference went away. There was still enough signal from 960 kHz for a usable signal.
I also had to continue the shield of the antenna connector of the receiver to the receiver box. I put 2 nuts on the antenna connector 1 on each side of the box and tightened them. This stopped the Sage power supply noise from getting into the receiver.
Thank you for the help, Tim
Tim Zook, Broadcast Services Department Technician
+1 574.970.4252 Ext. 236
Technology for abundant life!
From: Nathaniel Steele <firstname.lastname@example.org>
Sent: Thursday, March 30, 2017 4:38:18 PM
Subject: RE: [CRTech] AF310 manaual?
I thought i had a circuit diagram somewhere..im out ill check when i get back near a computer..
On March 30, 2017 2:27:46 PM Bill Hurne <email@example.com> wrote: