[CRTech] Christian Radio Tech [MSG 17324]
[Thread Prev] [-- Thread Index --] [Thread Next] [Date Prev] [-- Date Index --] [Date Next]
[no subject]
I had a very picky time with the receiver in Installation mode when I =
first
installed and went crazy, until I narrowed it down to a defective run =
from
our dish to the receiver.  Replaced that, and I was able to lock things =
up.

Wegener also provided me with a lot of help during my troubles.  Our
settings table was off a little bit too.

Mark


-----Original Message-----
From: wpio fm Titusville FL [mailto:wpio@gate.net]
Sent: Friday, September 30, 2005 11:49 AM
To: CRTech
Subject: Re: [CRTech] Unity4k Installation Mode - what meaneth this?


At first scan of the manual, I haven't found what:

ALARM
Installation Mode

refers to.

I wish I knew if the meaning of that alarm meant the same as no=20
signal, then I could deal with the LNB.

(there was not wind associated with the lightening hit so dish=20
pointing isn't a problem)

Randy Henry

---------------------------------------------------------------------
For CRTech resources visit http://CRTech.org/
To unsubscribe, e-mail: crtech-unsubscribe@crtech.org
List problems?=A0 E-mail: TechStaff@CRTech.org
Prev by date: [no subject]
(Unknown, Fri Jun 02 21:12:04 2017)
Next by date: [no subject]
(Unknown, Fri Jun 02 22:32:47 2017)
Prev by thread: [no subject]
(Unknown, Fri Jun 02 21:12:04 2017)
Next by thread: [no subject]
(Unknown, Fri Jun 02 22:32:47 2017)
CRTech.org